Should i saw off part of my composite stick or is it too risky
l have a RBK 7V kickzone composite one piece stick and it has worked
alright for pokechecking the puck and opponents underestimate my reach but
my shot is affected because its just a bit too long.Im looking to shave
about 2 inches off of it but im concerned that it will fracture or
shatter.Il use an electric saw to do it because it will cut cleaner.
/>RBK 7V sickick
Hopefully wherever you bought it would help you acheive the
right feel. It depends on what you wnat to sacrifice. The long reach or
a good shot. i would trim it to obtain the right shot and a little more
hard work to poke away those pucks.
I think a hacksaw would be best. A high speed electric would obliterate
the end of it. Slow and steady and deburr any ragged edges. Then tape that bad boy up and hit the ice!!
I think it would be a little risky. If you like taking risks do
it if not id just buy another one or keep using it how it is right now.
I would use a hack saw you have more control, It won't hurt the
structural integrity of the stick, but it will change the flex point. You
should be fine, put the stick in a vice (only tight enough to hold it,
don't kill it) grab the stick with one hand about a foot away from your
(marked) cut line, then start slowly and once you cut a guide line you can
speed up and cut through. Make sure you file down the cut before you tape
it.
5 posts
• Page 1 of 1
I am attempting to install child safety gates. Directions call for 9/64 drill bit. Can I use another What type of drill bit can be used to drill a hole in glass? Caprenter's pencil sharpener/drill bit is there a drill bit that can cut through ceramic tiles . I used a reg bit but the tiles break 5.8mm drill bit (.22) How do I drill a hole straight down a cylindrical piece of wood? What can I use to drill through a steel socket? The hospital left a broken drill bit in my leg ! Does anybody know of a good way to mount drill bits safely in a wood router? What kind of drill bits can drill through carbon steel? I'm trying to remove a broken tap made of carbon stee?? i dropped a drill bit into the battery water hole.....can that mess up the battery a drill bit usually sells for 45cents.you offer a 20% discount on a dozen or more.how much would 18 drill bit what is a sds drill bit, Could a drill bit through my ears Who is onlineUsers browsing this forum: 4 guests |